![]() Oh, and a vintage garbage headboard too! Needless to say, we’re fans. Nein! Nein! Nein! OK Fine by Clark+Kensington has been put to use on our dresser-turned-kitchen island, our original DIY porch swing (also a quick and easy quarantine DIY) and our sliding back doors (some incredible kitchen before and after photos in that one, BTW). You might recognize the pale pink as Benjamin Moore Odessa Pink from our recent bathroom board and batten project! The blue/black color is also oldie but a goodie. of all 54 blocks is sanded smooth and your hands are numb from the vibration of the sander, it’s time to paint the ends! We picked two complimentary colors that we had on hand and painted both ends of 27 blocks (half of the 54 total) in each color. If you’re looking for the easiest and most simple version of this project, stack the blocks in your Radio Flyer and call it done! If you’d like to add a bit of visual interest and open up the possibility of an alternate version of the standard Jenga game, it’s time to paint! 3| Paint, Paint, Paint We sanded a small bevel on the corners and made sure to give each freshly cut end a thorough sanding as well. The combination turned out to be a happy medium between smoothing the surfaces of the wood and removing any rough spots. If there’s not a power sander in your tool arsenal already, this project would likely be a good excuse to invest in one! We used 220 grit paper on medium speed with our random orbital sander (similar, ours is discontinued). Sanding removes any pesky splinters and ensures that your pieces slide as smoothly as possible. This is the most time-consuming step of the project, but also the most important. We’ll recycle our scraps as kindling for our next Tree House bonfire! 2| Sand, Sand, Sand. These only have the potential to snag on other pieces and make the game much less fun. Remember, a nominal 2″ x 3″ actually measures 1.5″ x 2.5″, so we’re shooting for exactly 7.5″ per piece.Īs cuts are made, it’s a good idea to remove any nasty knots or crummy boards. The goal here is for the length of one cut board to equal the exact width of three boards stacked side by side. We find that any time we’re making multiple cuts of the same length, clamping a slug to the miter saw’s fence will speed things up significantly! Just be sure to make a test cut or two to ensure things are measuring accurately. The first step in the process is to cut all of the boards to 7.5″ length.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |